Understanding How To Change A Broken Cord On A Sash Window

As sash windows age, so do the cords. They can break as time goes on. Fixing them, however, does not require one to be rich. As a matter of fact, no home improvement experience or expertise is needed. The tips that follow will explain How to change a broken cord on a sash window.

This home improvement task starts with pulling together all the tools needed. Included in the list are a utility knife, lubricant and screwdriver. Additional items one will need are new window cord roping, a putty knife and a hammer. As soon as the tools are gathered, one should begin by taking the window out of the frame.

Following window removal, the next step is to gain access to the sash cord. There are panels on some windows. However, older windows could be without them. If so, then, in addition to removing the window, the window casing needs to be removed.

At the start of the project, it is important to get access to the cords. On the side jambs, one will locate the access panel for those windows that have them. Getting the panel open will expose the weights, pulleys and cords. Take the sash weights out and remove any aging cord that is attached to them. Then, replace them and place them on top of a three to four inch thick wood block.

Check to make sure the window pulleys are clean. If not, clean them. Then, lubricate them. After that, do whatever is possible to make getting the cord roping fed through the pulley easier. One way to facilitate cord roping feeding is to tape new rope to the end of old rope. Take them out of the access panel. As the old ones are being pulled from the pulley, the new ones will be fed through it.

Sash weights contain a hole. The cord should be run through the hole in the weights. Tie a knot at the bottom of the cord roping. The rope will usually go two or three inches past the pulley. Do the same steps as were done on this side to the other side. Then, add trim and finish nails. Additionally, stain and finish can be added to fit the home’s decor and atmosphere.

It is not necessary to be a home improvement professional in order to fix a broken sash window cord. It also does not take much time. A little bit of time in an afternoon, the proper tools and the correct instructions will make changing cords possible. Follow these steps and one will know How to change a broken cord on a sash window.

Looking for more info on how to change a broken cord on a sash window ? Get the low down instantly in our overview of sash cord repairs and all you need to know about sash window repairs London .

Leave a Comment